You are here: Home > TECH CENTRAL > TST666 - Inner Ring Bearing Remover Instructions

TST666 - Inner Ring Bearing Remover

Tools Required:

TST666 - Inner Ring Bearing Remover

EZ301PRESS-S - EZ Press III or
TCE110-1 - Precision Arbor Press

Replacement Parts

SureFix Bearing Kit or ValuPak Bearing Kit or Bearings for handpiece you are repairing

Step 1

Align groove on bearing inner ring to match rise on Inner Ring Bearing Remover

Inner Ring Bearing Remover Step 1

Step 2

Slide turbine in direction of arrow until it stops

Inner Ring Bearing Remover Step 2

Step 3

Tighten thumb screw, then align under EZ Press Spindle Ram or Precision Arbor Press Pin and press down to remove bearing inner ring

Inner Ring Bearing Remover Step 3